Ls Valley Cover Torque Specs. Intake manifold bolts (in sequence) 89 lb in: The ls1 system just happens to force oil along with the air as well, so gm seemed to take a stab at fixing the issue with the ls6 system.
The specs listed are for stock fasteners. Bell housing to engine block. Accumulator cover to case bolt:
Table of Contents
A/C Compressor And Condenser Hose Bolt (At Accumulator) 16 Nm 12 Lb Ft.
The specs listed are for stock fasteners. Detent spring to valve body bolt: All torque specifications w/ cmd #3 high pressure lube 7/16 = 65 ft lbs 3/8 = 35 ft lbs 8mm = 22 ft lbs weight:
Clean And Inspect All Hardware Prior To Installation.
Factory ls cover and front seal 2005 w/ cam sensor provision torque specs: The ls1 system just happens to force oil along with the air as well, so gm seemed to take a stab at fixing the issue with the ls6 system. Finish off your ls valley pan cover installation with flange bolts from ict billet.
Answer Id 5191 | Published 03/22/2019 02:03 Pm | Updated 11/12/2019 02:46 Pm
Valley cover bolts 25 n·m 18 lb ft valve lifter guide bolts 10 n·m 89 lb in valve rocker arm bolts 30 n·m. The ls6 setup pulls the pressure not from the valve cover, but from the valley cover. Converter housing to case screw:
Converter Housing To Case Screw :
The specs listed are for stock fasteners. Case extension to case bolt: Intake manifold bolts (in sequence) 89 lb in:
Specification Metric English • Second Pass 35Y 26Lbft • Third Pass 55Y 41Lbft • Final Pass 70Y 52Lbft Connecting Bearing Cap To Connecting Rod Retaining Bolt (L98, Ls3, L76, L77) • First Pass 20Y 15Lbft • Second Pass +85Degrees Coolant Air Bleed Pipe And Hole Cover To Cylinder Head Retaining Bolt 12Y 106Lbin Coolant Temperature Sensor 20Y 15Lbft
If you use arp fasteners, follow the instructions that came with your new hardware. The rockers are zero lash, when you find out what length push rods you need heres the proper way of torquing the rocker arms. 25 nm 18 lb ft.